If you need to use the Extension Arms, you must use all Extensions Arms in order for the Mount to properly hold your TV. If you have an oversized LCD/ Plasma TV, you may need to use the Extension Arms provided.

Once the Tilts Arms are slid onto the Horizontal Adjustment Bar, screw on End Caps.Īttaching Extension Arms: (Note: Some models not included) 4. Unscrew the End Caps from both sides and attach the Tilt Arms by sliding them on (Figure7). Laying the television down on the glass may cause permanent damage. Using as a Tilt Mount: NOTE: NEVER LAY YOUR TELEVISION FACE DOWN ON ITS GLASS. Tighten bolts firmly with a Phillips screwdriver. Please see Diagram 1 below for a detailed drawing. For a flat back Plasma/LCD that required a M4 or M5 diameter bolt, thread a M4 x 12(A) or a M5 x 12(C) bolt through the appropriate Lock Washer(L,M), an M4/M5 Washer, the Tilt Arm and into the TV. Wall Plate specifically to hold LCD TV’s 34” - 65” and a maximum weight of up to 200lbs.Īttaching Monitor Bracket to a LCD/Plasma with: FLAT BACK RECESSED BACK Plasma/LCDs with a flat back panel will require a shorter bolt. Do not screw too tight until all the screws are in. English Installation instructions Fixed/Tilt Plasma/LCD Wall Mount Model: FT65-03*, FT65B-CC*, ELLCDM07,ELLCDP-07, LM50CDM, DC50CDM, LM60T, DC60T, LM65FT*, DC65FT* ! CAUTION This wall mount was designed wall, screw 1 Dry Wall Screw and 1 Dry Wall Washer (P & Q) in the upper left mounting hole of the Wall Plate.

Elexa levelmount